Home › Methodology
How we calculate
Runtime
hours = capacity (Wh) × 0.95 ÷ (appliance W ÷ 0.9 + idle W)
- 95% usable capacity: the battery management system stops before 0%, and capacity fades with age.
- 90% inverter efficiency: turning battery DC into 230 V AC wastes energy as heat. Typical inverters manage 85-92% at medium and high load.
- Idle draw: the inverter itself uses power while on, which matters for small loads like a router. Brands rarely publish it, so we use 5 W (≤300 Wh), 8 W (≤800 Wh), 12 W (≤1.6 kWh), 18 W (≤2.5 kWh) and 25 W (bigger).
- Together this gives an overall efficiency of roughly 80-85% for typical loads, which matches independent tests.
Can it run it?
- Running watts above the inverter's continuous rating: no.
- Heating loads (kettle, heater) above the rating: X-Boost / SurgePad can run them at reduced power by lowering voltage. Motors cannot use this.
- Motors and compressors need a short start-up peak (fridges ~5-6× running power, saws and pumps ~2.5-3×). We compare it with the published surge rating; if the brand publishes none, we say so.
Cycling appliances
Fridges and freezers switch on and off. We use their long-run average (for example 35 W for a fridge-freezer using about 300 kWh a year) for runtime, and the start-up peak for the surge check.
Charges (phones, laptops, e-bikes)
charges = energy delivered × 0.85 (charger losses) ÷ device battery Wh.
Solar
Daily energy = panel W (capped at the station's max solar input) ÷ 1000 × PVGIS kWh/kWp/day × 0.95. PVGIS v5.3 monthly averages, 14% system loss, best fixed tilt (or vertical for balconies).
Sources and dates
- Power station specs: official brand product pages, linked on every page, checked 2026-11-15.
- Appliance watts: typical EU/UK nameplate values; Penn State EGEE 102 for general ranges.
- Solar: PVGIS, EU Joint Research Centre, fetched 2026-11-15.
These are estimates for planning. Cold weather, battery age, firmware and your exact device change the result. Medical devices: ask your supplier.